© DenLorsTools.com Summary: In this automotive repair article we cover timing belt R&R instructions on the Mitsubishi 2.4 L SOHC engine and the recommended replacement interval. We list the different makes and models that use this particular engine. Automotive repair questions and answers are included along with a diagram for timing belt marks.

The Mitsubishi 2.4 Liter SOHC engine is used in the Eclipse, Galant and Outlander. Many people are unaware that the engine is also used in the Chrysler Sebring and Dodge Stratus. It’s important to know that the 2.4 is an interference engine that may end up with bent valves and possibly damaged pistons if the timing belt strips or breaks during driving. The motor includes a main timing belt and a smaller balance shaft belt. Both of these should be replaced at the same time. The manufacturer recommended replacement interval is every 60,000 miles.

Read the rest…

Summary: This auto repair blog post provides a quick easy way to check for a vacuum leak that can cause lean codes on Ford Windstars.

Ford seems to have more than it’s reasonable share of lean codes, the Ford Windstar is no exception. If all the usual suspects have been investigated and no leaks were found, there’s another possible cause of a lean code when diagnosing a Ford Windstar. At one time I had so many of these vehicles to work on… I kept a parts list! In my notebook, I kept a list of part numbers that made writing up an estimate for repairs much easier. Later, when I used the computer at work more I converted my notes over to a “Word Document” file that allowed me to copy paste. When you work Flat Rate, you learn to save time when you can! Back to the subject at hand. In this auto repair article we briefly cover a common cause of lean codes on the Ford Windstar.

Read the rest…

2003 Jeep Grand Cherokee 4.0 Liter Engine with a P1281 Code.

This automotive repair article is on a specific check engine light code for a Jeep Grand Cherokee. When scanned with an automotive scan tool, a P1281 fault code was retrieved. The code has to do with the engine not reaching operating temperature within a certain length of time after the vehicle has been started. For the catalytic converter to operate at it’s best the engine needs to reach it’s normal operating temp. The cooling system’s thermostat normally stays closed when the engine is cold, allowing the motor to warm up quickly. That’s why the trick of removing the thermostat to let the car run cooler, like back in the 1970’s (prior to on-board computers) doesn’t work well anymore.

Read the rest…

Pictures are of a 2004 Dodge Stratus like the Chrysler Sebring – click on images for a larger view.

© DenLorsTools.com Summary: In this automotive repair blog, we provide some helpful information on how to R&R (Remove and Replace) the evaporator in a 2004 Dodge Stratus. Replacing the heater core is basically the same job, except for the replacement of the receiver drier. These tips are for the 4 door sedan, yes the the coupe and the convertible may be different depending on the year. If working on a different model or year it would be advisable to refer to an auto repair manual. Auto repair manuals provide detailed info on changing components like the evaporator in any model. Just keep in mind that for evaporator or heater core replacement, most of them will say “see removal of instrument panel.” Which is accurate except for the fact that if all you’re doing is moving the dash to access the evaporator case, dismantling the dash isn’t really needed. If the instrument panel is removed as described in most auto repair manuals, many more parts will be removed unnecessarily.

Read the rest…

This Kia Rio had a severe engine vibration, see the picture below for the cause.

© DenLorsTools.com Summary: Suggestions of what to check when a car has excessive drivetrain vibrations. There are several things that can cause an engine to shake. If there is an engine vibration problem, typically it gets worse with the air conditioning turned on since there is more of a load on the engine. In this auto repair article, we will cover several things that can be looked at to help diagnose the problem.

Misfires can definitely cause an engine to shake, usually in most late model cars a misfire will almost always be accompanied by a CEL (Check Engine Light) and misfire code. Many times if the engine also stalls, there could be excess carbon build up on the throttle plates or IAC (idle air control motor). Cleaning the throttle body and IAC is a common practice when trying to eliminate possible causes of engines vibrating.

Read the rest…

Honda Ridgeline is one of the vehicles affected by TSB 08-045

Honda has always been a little different when its comes to their TSB’s (Technical Service Bulletins). They have used terms that are down to earth, that mechanics can understand easily. Plenty of technical information but without all the technical talk. Honda has now gone above and beyond their previous efforts to inform technicians about issues and fixes. The PDF provided by Honda not only has pictures, it has video and sound!

Read the rest…

Chrysler 300 with only 37,000 miles overheated & towed in

What would cause two cooling fan motors to be out at the same time? One possibility is that they didn’t fail at the same time, one failed and the car was still able to be driven until the other failed also. But two fan motors failing on a car that only has 37,000 miles didn’t make sense either. Obviously power and ground supply was first checked with a power probe to verify the motors were getting the correct input to allow them to run. Once the fan motors were replaced, a terrible ticking noise was heard. More pictures below:

Read the rest…

2000 Ford Expedition P0401 doesn’t necessarily mean the EGR is bad

Summary: Ford DPFE problems discussed. Common causes for Ford EGR low flow issues and P0401 fault code triggered. Don’t replace the EGR (Exhaust Gas Recirculation) valve just yet if you have a P0401 code on a 4.6 liter engine like the one in this Expedition. The diagnostic code definition states “Low flow from E.G.R.” Low flow doesn’t mean definitively that the EGR is bad. Low EGR flow can be a problem in any Ford, Mercury, Lincoln, Mazda and many other car’s for that matter. On a lot of Ford vehicles this code will mean there is a faulty Differential or Delta Pressure Feedback (DPFE) sensor. This was such a common problem there was an extended warranty coverage on them for awhile. Not many people knew about Ford covering these on some models for an extended period of time. At the shop I worked at, an extended warranty company first alerted us to this when they declined an extended warranty claim because Ford would replace it under warranty.

Read the rest…

Wiring can cause door lock problems, but switches and actuators are more common.

DennisB DenLorsTools.com © Summary: A quick common sense way of thinking about and pinpointing the most common door lock problems on many vehicles. There are several things that can cause the power door locks not to work properly. The most common cause of a single door lock not to work, is a bad door lock actuator (also called a door lock solenoid or door lock motor). Another common problem or cause of door locks not working is simply a bad door lock switch. Many cars today have computers that are also in the loop when it comes to controlling the door locks.

Fortunately, body computer systems are pretty dependable and give problems very seldom. It seems as though the most troublesome vehicles regarding door locks related to computer control issues, are Chrysler’s; Dodge Caravan and Chrysler Town & Country vans sometimes have BUS related issues (BUS means “a collection of wires through which data is transmitted from one computer to another”)… but this is still rare. Ford Explorers also have a few BUS issues that can be related to door lock security module, or wiring shorting out that goes from the door into the body. Usually when checked with a scan tool in the body control or security section, there will be a code indicating if there’s a BUS fault.

Read the rest…

Leaves accumulated near the fresh air intake can enter the car’s evaporator case.

© DenLorsTools.com Summary: Article on low flow from air conditioning vents in cars. Neglected cabin air filters are the leading cause of this issue. Although, there are several things that can cause low airflow from a vehicle’s air conditioning system. The strongest blowing vents are the middle ones with the setting adjusted to maximum or recirculate. On the max setting, the air is recirculated in the passenger compartment. Obstructions can include leaves, loose articles from the glove-box, a broken or out of position door in the Heating Ventilating & Air Conditioning (HVAC) case.

Read the rest…